The humidifier is designed to work with all air handling units. The device is used to maintain the required humidity in the building. The action is based on the natural process of water evaporation, this process is the most beneficial for our health, and is also very energy-efficient. This solution ensures the maintenance of humidity in the building during the winter, when the humidity is low. Properly installed device does not require any maintenance apart from periodic replacement of the steam mat.
Thanks to the new configuration, the device can be connected to any existing installation and any recuperator. The humidifier is installed on the supply air duct of the ventilation system and is an independent device. It is controlled by a controller mounted at the top, which is standard equipment of every WANAS UNI humidifier. Due to the combination with the wireless miniControl sensor, humidity control is easy and fully automatic.
BENEFITS:
Max. flow rate |
m3/h | 1300 | |
Energy consumption |
W | 2-18 | |
Power supply |
V/Hz | 230/50 | |
Stub pipe diameter | mm | 315 | |
Height/Width/Depth |
mm | 937/455/452 |
|
Weight |
kg | 36 | |
Heater power |
W | 2 000 | |
Nominal capacity |
l/h | 2,8 | |
Maximum water consumption |
l/h | 10,1 | |
Air resistance at 200 m3/h |
Pa | 7 | |
Water connector diameter |
cal | 3/4 | |
Water pressure |
MPa | 0,15-0,6 | |
Water temperature |
Min/max | 5-20 | |
Environment temperature |
Min/max | 5-45 | |
Water hardness |
Max mg CaCo3 | 200 |
A – air supply to rooms/air supply to humidifier
B – air supply to rooms/air supply to humidifier